Alaska Guide Creations Alaska Classic Max - Gen L Binocular Case - Ranger Green

Alaska Guide Creations Alaska Classic Max - Gen L Binocular Case - Nothing beats the "Original." The Alaska Classic offers the classic design features of the original binocular harness chest pack Jaret developed 40+ years ago with today’s modern advancements in innovation and durability. These are Alaska's mid-size line and are meant to accommodate full-size binoculars up to around 50mm objective lenses. For example, most 10×50 and 12×50 binoculars would fit perfect in the regular harnesses. Main Compartment measurements are approximately 6.75-inch tall x 6.5-inch wide x 3.5 inches deep. Front Compartment measurements are approximately 4.5-inch tall x 6-inch wide x 1.5 inches deep. Side Compartment measurements are approximately 2.5-inch wide x 1 inch deep. Rear Compartment measurements are 6-inch tall x 6.5 inches wide (flat).

The M.A.X. pocket option adds one additional pocket at the bottom of the pack that is about 1 inch tall and is the same depth and width as the main compartment.  This pocket is perfect for storing a light pair of gloves, headlamp, Outdoor Edge Knife and blades, or any other small necessities.

Upgrades include the addition of 3 molle straps on the bottom of the pack, the Gen L Harness, and the Pro Tethers.

The Gen L (Celebrating 50 years of innovation) Harness is a slim, padded harness that allows the user to completely contain excess webbing within the shoulder straps to eliminate dangling webbing and provide a clean, comfortable finish.   

The Pro Tethers connect directly to the Gen L Harness at the grommet located at the point of the shoulder straps.  They also connect easily to other AGC Harnesses through the slot on the male buckle or 3 bar slider.  The Pro Tethers are 3/8” elastic webbing that secure and protect optics in the event of a drop, but also allow for them to be easily detached when required.  To attach and detach the optic from the tether, simply rotate the custom tether clip 90 degrees and slide the tether loop through the slot of the clip.  The black micro cord loop/tether clip can then be attached through the attachment location of the optic by slipping the micro cord through the optic attachment point then back over the tether clip.  Reattach the tether clip to the 3/8” tether loop in the same fashion you removed it.

Each Gen L Alaska Classic Max comes complete with the matching Gen L Harness and a set of the all new Pro Tethers attached.